Engine/Transmission - Arctic Cat HDX CREW 2017 Service Manual

Engine/Transmission

This section has been organized into sub-sections which
show a progression for the complete servicing of the Arc-
tic Cat ROV engine/transmission.
NOTE: For efficiency, it is preferable to remove and

disassemble only those components which need to be
addressed and to service only those components. The
technician should use discretion and sound judgment.
AT THIS POINT

To service any one specific component, only limited dis-
assembly of components may be necessary. Note the
AT THIS POINT information in each sub-section.
To service the center crankcase halves, the engine/trans-
mission must be removed from the frame. To service top-
side, left-side, and right-side components, the engine/
transmission does not have to be removed from the
frame.
 NOTE: Arctic Cat recommends the use of new gas-
kets, lock nuts, and seals and lubricating all internal
components when servicing the engine/ transmission.
NOTE: A new ROV and an overhauled ROV engine

require a "break-in" period. The first 10 hours (or
200 miles) are most critical to the life of this ROV.
Proper operation during this break-in period will
help assure maximum life and performance from the
ROV. Instruct the customer to follow the proper
break-in procedure as described in the Operators
Manual.
SPECIAL TOOLS
A number of special tools must be available to the techni-
cian when performing service procedures in this section.
Refer to the current Special Tools Catalog for the appro-
priate tool description.
NOTE: When indicated for use, each special tool

will be identified by its specific name, as shown in the
chart below, and capitalized.
Description
Seal Protector Tool
Crankcase Separator/Crankshaft Remover
Magneto Rotor Remover Set
Piston Pin Puller
Secondary Drive Gear Holder
Spanner Wrench
Surface Plate
V Blocks
NOTE: Special tools are available from the Arctic

Cat Service Department.
p/n
0444-252
0444-152
0444-254
0644-328
0444-253
0444-240
0644-016
0644-535
39