Hydraulic Brake Caliper - Arctic Cat HDX CREW 2017 Service Manual

PR252A
INSTALLING
1. Secure the brake disc (if applicable) to the hub with
the four cap screws coated with red Loctite #271.
Tighten to 15 ft-lb.
2. Apply grease to the splines in the hub.
PR254B
3. Install the hub assembly onto the axle; then place the
transmission in park.
PR961
4. Secure the hub assembly with the nut. Tighten to 200
ft-lb; then install the hub retaining plate.
NOTE: If the hub retaining plate cannot be inserted

due to misalignment of the hole in the axle and the
slots in the nut, tighten the nut until properly aligned.
136
PR965
5. Secure the brake calipers to the knuckle with two
new "patch-lock" cap screws tightened to 20 ft-lb.
PR264A
6. Install the wheels and using a crisscross pattern,
tighten the wheel nuts in 20 ft-lb increments to a final
torque of 40 ft-lb (steel wheel), 60 ft-lb (aluminum
wheel w/black nuts), or 80 ft-lb (aluminum wheel w/
chrome nuts).
7. Remove the vehicle from the support stand.

Hydraulic Brake Caliper

! WARNING
Arctic Cat recommends only authorized Arctic Cat ROV
dealers perform hydraulic brake service. Failure to
properly repair brake systems can result in loss of con-
trol causing severe injury or death.
REMOVING/DISASSEMBLING
1. Secure the vehicle on a support stand to elevate the
wheel; then remove the wheel.
! WARNING
Make sure the vehicle is solidly supported on the sup-
port stand to avoid injury.
! WARNING
Never let brake fluid contact the eyes. Damage to the
eyes will occur. Always wear appropriate protective
safety goggles and latex gloves when handling brake
fluid.