Installing Left-Side Components - Arctic Cat HDX CREW 2017 Service Manual

REPLACING STATOR COIL/
CRANKSHAFT POSITION SENSOR
1. Remove the three cap screws securing the stator coil,
two cap screws securing the crankshaft position sen-
sor, and one cap screw from the harness hold-down.
2. Lift the rubber grommet out of the housing; then
remove the stator coil/crankshaft position sensor.
Account for and note the position of the harness
hold-down under the crankshaft position sensor.
FI590
3. Install the new stator coil assembly and secure with
three new "patch-lock" cap screws. Tighten to 13 ft-
lb.
4. Place the stator wire harness hold-down into posi-
tion; then install the crankshaft position sensor and
secure with two cap screws. Tighten securely.
5. Install the upper cable hold-down and secure with a
cap screw. Tighten securely.
FI595A
Installing Left-Side
Components
 NOTE: Plug the oil passage in the crankcase hous-
ing prior to installing the drive gear/driven gear
assembly to prevent loss of an alignment pin.
1. Install the water pump driven gear alignment pin and
the driven gear (with the beveled side of the gear fac-
ing outward as noted in removing); then secure with
the snap ring.
CD950A
CD952A
CD949
NOTE: The sharp side of the snap ring should be

facing outward.
2. Install the water pump drive gear drive pin and the
drive gear (with the flat side of the gear facing out-
ward as noted in removing); then secure with the
snap ring.
CD946A
65