Setup - Life Fitness Integrity Series Operation Manual

1

SETUP

Read the Operation Manual before setting up the Life Fitness Cross-trainer. Place the
cross-trainer where it will be used before beginning the setup procedure.
WHERE TO PLACE THE LIFE FITNESS® CROSS-TRAINER
Follow all Safety Instructions in Section 1.1 and move the Life Fitness Cross-Trainer to the
location in which it will be used. See Section 4, Specifications, for the dimensions of the
footprint. Allow 1 foot of clearance in front of the Life Fitness Cross-Trainer to allow for
movement of the pedal levers and at least 2 ft. (0.6 m) on the side. It should be easy to
mount the Life Fitness Cross-Trainer from the side.
HOW TO STABILIZE THE LIFE FITNESS CROSS-TRAINER
After placing the Life Fitness Cross-Trainer in position, check the unit's stability by attempting to rock it. Any slight rocking
indicates that the unit must be leveled. Check the stabilizing feet to determine which foot does not rest fully on the floor.
Rotate the foot counter-clockwise to lower it. Recheck the stability and adjust again as needed until the Life Fitness
Cross-Trainer is stable and no longer rocks. Lock the adjustment into position by tightening the jam nut against the
stabilizer bar with an open end 9/16 inch wrench.
CHECK FOR POWER
The console is powered by a rechargeable 6-volt battery. Check the battery by pressing the START key. The console
should light up, and the MESSAGE CENTER should display a prompt to set up a workout. If this does not occur, mount
the Life Fitness Cross-Trainer and begin pedaling. The console should then light up, making it possible to program a
workout. Pedal for 10 to 20 minutes at 1.5 mph (2.4 kph) or faster during a workout to charge the battery. Afterwards, the
pedal action during workouts keeps the battery charged. If the console still does not light, contact Life Fitness Customer
Support Services (see page one of this manual for more information).
FITNESS AND ENTERTAINMENT NETWORKING
Two interchangeable network ports allow the Life Fitness Cross-Trainer to be connected to a fitness entertainment system
and/or a network, such as FitLinxx™ interactive fitness network.
• Networking: The built-in networking ports allow the unit to exchange workout information with a fitness network
database.
Fitness Entertainment: The network connection enables the console to power a third-party receiver for use with a
•
service such as the Cardio Theater® entertainment system or the BroadcastVision™ entertainment system.
These ports are located on the back of the console and are enclosed by a removable cover. Any use of the ports for other
than their intended purpose could void the product warranty.
1 ft" (0.3 m)
2 ft. (0.6 m)
2 ft. (0.6 m)
9