Adjusting The Clock; Before Operation - Sanyo DC-MCR80M Instruction Manual

Micro component system
Hide thumbs Also See for DC-MCR80M:
Table of Contents

Advertisement

When the unit is first connected to the AC power line, the clock display
blinks on the display.
Example: To set "PM6:30".
First, press the z/ON button to turn the power off. The clock display
appears dimly.
1. Press the MEMORY button for at least 2 seconds.
The hours display blinks.
2. Press the f or e button to set the "hours".
3. Press the MEMORY button.
The minutes display blinks.
Turning the power on and off
Press the z/ON button, the display light.
To turn the power off, press the z/ON button again. The clock display
remains lit dimly.
-
When the mains lead is connected to the AC outlet, the unit will
respond to commands from the remote control.
Adjusting the volume
Turn the VOLUME control, or press the VOLUME - or + button on the
remote control. The volume level appears by numbers (VOL MIN ~
VOL MAX) on the display.
Bass expander system
Press the BASS button to enhance the bass sound. "BASS ON"
appears briefly on the display.
Selecting the sound mode
Press the SOUND PRESET button to select the sound mode matching
the music to be listened to.
ROCK: Rock music, etc.
JAZZ: Jazz, etc.
CLASSIC: Classical music, etc.
POP: Pops, etc.
FLAT: Flat music, etc.

ADJUSTING THE CLOCK

BEFORE OPERATION

-5-
4. Press the f or e button to set the "minutes".
5. Press the MEMORY button. The clock starts dimly.
-
The time can be set accurately by pressing the MEMORY but-
ton when a time signal is heard.
-
If a power failure occurs or the mains lead is disconnected, the
clock display blinks. Reset the time again.
WHAT TO DO IF ...
If the operation of the unit or display is not normal,
1. Disconnect the mains lead.
2. Press the RESET button (right side of the unit) for at least 30 sec-
onds
3. Connect the mains lead.
4. Resume the operation.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents