Before Operation; Adjusting The Clock - Sanyo DTA-200 Instruction Manual

NOTE:
When the unit is first connected to the AC power line, the clock display
blinks on the display.
Example: To set "6:30"
1. First, press the z/ON button to turn the power off. Only the clock
display appears.
2. Press the MEMORY button.
(There is the MEMORY button behind the buttons door. Push the
buttons door (PUSH OPEN portion) to open it).
The hours display blinks.
3. Press the TIME SET + or – button to set the "hours".
Turning the power on and off
Press the z/ON button. The display lights and "WELCOME" blinks briefly.
To turn the power off, press the z/ON button again. "GOOD BYE" ap-
pears briefly and the clock display remains lit.
- When the main lead is connected to the AC outlet, the unit will re-
spond to commands from the remote control.
Opening or Closing the buttons door
Press the buttons door (PUSH OPEN portion) to open it.
You can see many buttons and use them.
Push the buttons door (PUSH OPEN portion) back into position to close
it.
Notes:
- You can press the q OPEN/CLOSE button only when buttons door
is closed.
- If you press the q OPEN/CLOSE button when the buttons door is
opened, "DOOR" blinks on the display.
Selecting the function
Press the FUNCTION button to select the desired function. Each time
the button is pressed, the display changes as follow:
CD v TUNER v AUX v CD v . . .
The function is automatically selected when CD play is started or when
the TUNER/BAND button has been pressed.
- When the function selection is changed, CD play is automatically
stopped.

ADJUSTING THE CLOCK

BEFORE OPERATION

(Main unit only)
5. Press the MEMORY button.
The minutes display blinks.
6. Press the TIME SET + or – button to set the "minutes".
7. Press the MEMORY button. The clock starts.
- The time can be set accurately by pressing the MEMORY but-
ton when a time signal is heard.
- To display the clock during operation, press the DISPLAY button
briefly. After a few seconds, the original display returns.
- If a power failure occurs or the main lead is disconnected, the clock
display blinks. Reset the clock again.
Adjusting the volume
Turn the VOLUME control, or press the VOL + or VOL – button on the
remote control. The volume level appears by numbers (VOL MIN - VOL
MAX) on the display.
Bass expander system
Press the BASSXPANDER button to enhance the bass sound, "BASS"
appears on the display.
Selecting the sound mode
Press the SOUND PRESET button to select the sound mode matching
the music to be listened to. Each time the button is pressed, the display
changes as shown below:
POP: Pops, etc.
ROCK: Rock music, etc.
CLASSIC: Classical music, etc.
JAZZ: Jazz, etc.
WHAT TO DO IF ...
If the operation of the unit or display is not normal even thought the
apporpriate buttons have been pressed.
1. Disconnect the main lead.
2. Connect the main lead again.
3. Within 5 seconds, while holding the MEMORY button down (main
unit), press the SNOOZE button (main unit).
-6-