Adjusting The Clock; Before Operation - Sanyo DTA-300M Instruction Manual

NOTE:
When the unit is first connected to the AC power line, the clock display
blinks on the display.
Example: To set "6:30"
1. First, press the z/ON button to turn the power off. Only the clock
display appears.
2. Press the CLOCK/TIMER button for at least 1 second.
The hours display blinks.
3. Press the f or e button to set the "hours".
4. Press the MEMORY button.
The minutes display blinks.
Turning the power on and off
Press the z/ON button. The display lights.
To turn the power off, press the z/ON button again.The clock display
remains lit.
- When the AC adaptor is pluged into to the AC outlet, the unit will
respond to commands from the remote control.
Selecting the function
Press the FUNCTION button to select the desired function. Each time
the button is pressed, the display changes as follow:
CD v TU(tuner) v CD v . . .
The function is automatically selected when CD play is started or when
the TUNER/BAND button has been pressed.
- When the function selection is changed, CD play is automatically
stopped.
Adjusting the volume
Press + or - VOLUME button. The volume level appears by numbers
(VOL 00 ~ VOL 30) on the display.
Bass expander system
Press the BASS button to enhance the bass sound. "BASS" appears
on the display.
Selecting the sound mode
Press the SOUND button to select the sound mode matching the music
to be listened to. Each time the button is pressed, the display changes
as shown below:
ROCK: Rock music, etc.
JAZZ: Jazz, etc.
POPS: Pops, etc.
CLAS: Classical music, etc.

ADJUSTING THE CLOCK

BEFORE OPERATION

-4-
5. Press the f or e button to set the "minutes".
6. Press the MEMORY button. The clock starts.
- The time can be set accurately by pressing the MEMORY but-
ton when a time signal is heard.
- To display the clock during operation, press the CLOCK/TIMER but-
ton briefly. After a few seconds, the original display returns.
- If a power failure occurs or the main lead is disconnected, the clock
display blinks. Reset the clock again.
WHAT TO DO IF ...
If the operation of the unit or display is not normal even thought the
appropriate buttons have been pressed.
1. Unplug the AC adaptor.
2. Plug the AC adaptor again.
3. Within 5 seconds, while holding the FUNCTION button down (main
unit), press the n button (main unit).