Before Operation; Adjusting The Clock - Sanyo DC-DA380 Instruction Manual

NOTE:
When the unit is first connected to the AC power line, the clock display
blinks on the display.
Example: To set "PM 6:30",
First, press the z/ON button to turn the power off. Only the clock display
blinks.
1. Press the CLOCK/TIMER for at least 2 seconds. " " blinks on the
display.
2. Press the MEMORY button.
The hours display blinks.
3. Turn the VOLUME control to set the "hours".
4. Press the MEMORY button.
The minutes display blinks.
Turning the power on and off
Press the z/ON button. The display lights and "WELCOME" appears
briefly.
To turn the power off, press the z/ON button again. "GOODBYE"
appears briefly and the clock display remains lit.
- When the mains lead is connected to the AC outlet, the unit will
respond to commands from the remote control.
Direct start function
If the following buttons are pressed when the unit is in standby, the
unit turns on automatically and the selected function is set.
CD section
i
q OPEN/CLOSE
Deck section b, a
Tuner section TUNER/BAND
Remote control i, OPEN/CLOSE, b, a, TUNER/BAND,
VIDEO
Selecting the function
Press the FUNCTION button to select the desired function. Each time
the button is pressed, the display changes as follows:
CD v TAPE v TUNER v VIDEO:AUX v CD v . . .
The function is automatically selected when CD play or tape playback is
started or when the TUNER/BAND button has been pressed (except
during recording).
- When the function selection is changed, CD play or tape playback is
automatically stopped.

ADJUSTING THE CLOCK

BEFORE OPERATION

(Main unit only)
5. Turn the VOLUME control to set the "minutes".
6. Press the MEMORY button. The clock starts.
- The time can be set accurately by pressing the MEMORY button
when a time signal is heard.
- To display the clock during operation, press the CLOCK/TIMER
button briefly. After a few seconds, the original display returns
- If a power failure occurs or the mains lead is disconnected, the clock
display blinks. Reset the time again.
Changing the clock to the 24-hour display
1. Press the z/ON button to turn the power off, and present time
display.
2. While clock is displaying, press the MEMORY button and hold it,
then press the i button.
Example: PM 1:00 v 13:00
To return the original setting, repeat steps above.
Adjusting the volume
Turn the VOLUME control, or press the + or – VOLUME button on the
remote control. The volume level appears by numbers (VOL 0 ~ VOL
MAX) and bar-graph on the display.
Surround sound system
Press the SURROUND button. "SURROUND" appears on the display
and a "wide" effect is created.
Bass expander system
Press the BASSXPANDER button to enhance the bass sound. "BASS"
appears on the display.
Selecting the sound mode
Press the SOUND PRESET button to select the sound mode matching
the music to be listened to.
POP: Pops, etc.
CLASSIC: Classical music, etc.
ROCK: Rock music, etc.
JAZZ: Jazz, etc.
Selecting the display backlight colour
The display has three colours of the backlight (Amber, Purple, Blue).
Press the DISPLAY button to select the desired display backlight colour.
WHAT TO DO IF ...
If the operation of the unit or display is not normal,
1. Disconnect the mains lead.
2. Press the RESET button (rear of the unit) for at least 30 seconds.
3. Connect the mains lead.
4. Resume the operation.
-5-