Inserting Batteries; Adjusting The Clock - Sanyo DC-DAB03 Instruction Manual

Inserting batteries

1.
Notes:
Always remove batteries if the remote control is not to be used for a month
or more. Batteries left in the unit may leak and cause damage.

ADJUSTING THE CLOCK

When the unit is first connected to the AC power line, "DAB/MP3" blinks.
To cancel this mode, turn the power on or press the
button.
Example: To set "6:30",
First, press the z/ON button to turn the power off. Only the clock display
appears dimly. If the main unit is in economy mode, press the
CLOCK/TIMER button till the clock display appears.
1. Press the MEMORY button for at least 3 seconds.
The hours display blinks.
2. Turn the VOLUME control to set the "hours".
3. Press the MEMORY button.
The minutes display blinks.
2.
Two R03/AAA batteries
(not supplied)
/CLOCK/TIMER
or
Remote control range
Remote sensor
The buttons on the remote control perform similar functions to similarly
marked buttons on the front panel.
(Main unit only)
4. Turn the VOLUME control to set the "minutes".
/ 5. Press the MEMORY button. The clock starts.
- The time can be set accurately by pressing the MEMORY button when
a time signal is heard.
- To display the clock during operation, press the
button briefly. After a few seconds, the original display returns.
- If a power failure occurs or the mains lead is disconnected, and the
clock display blinks. Reset the time again.
Changing the clock to the 12-hour display (Using the main unit)
1. Press the z/ON button to turn the power off, press the
TIMER button till present time displays.
2. While clock is displaying, press the n button and hold it, then press
the FM MODE/DISPLAY button.
Example: 13:00 v PM 1:00
To return the original setting, repeat steps above.
-4-
Within approx. 7 meters
30˚ 30˚
SLEEP
/ON
FUNCTION MEMORY OPEN/CLOSE
MUTE OVER
/CLOCK/TIMER
/CLOCK/