Section 9: Speed Control Programming; Section 10: Lubricating The Drive Shaft - Horizon Hobby miss elam Owner's Manual

Section 9: Speed Control Programming

The ESC in your Miss Elam Brushless EP
is preprogrammed from the factory. The
programming is set for Ni-MH batteries as
shipped with your Miss Elam.
A programming module (PRB3311) is
available to change the programming of
your speed control. Settings include Ni-MH
or LiPo batteries, cutoff voltage settings,
cutoff type, brake on or off, motor timing
and throttle curve. The brake and motor
timing adjustments can be adjusted without
the programming module. See the ESC
instructions for details.

Section 10: Lubricating the Drive Shaft

Lubricating the flex shaft is vital to the life
of the drivetrain. The lubricant also acts as a
water seal, keeping water from entering the
hull through the stuffing box.
Lubricate the flexshaft, propeller shaft
and all moving parts after every 2–3 hours
of operation.
 1. Use either two crescent wrenches, two
10mm wrenches, or a combination of
either to loosen the collet nut.
Caution: It is imperative that you do not
attempt to use LiPo batteries in the Miss
Elam Brushless unless it has been properly
programmed or serious damage to the
batteries and electronics may occur.
 2. Remove the 3mm setscrew that secures
the flex shaft to the propeller shaft.
9