Horizon Hobby miss elam Owner's Manual
Horizon Hobby miss elam Owner's Manual

Horizon Hobby miss elam Owner's Manual

1/12 brushless ep catamaran boat

Advertisement

Quick Links

®
Miss Elam 1/12 Brushless EP Catamaran Boat
Owner's Manual

Specifications

Hull Length .................................................................................... 26 in (660mm)
Beam ........................................................................................... 8.3 in (210mm)
Motor ............................... Water-cooled Hi-performance A3630-1500 Brushless Motor
Radio System............................................................ Pro Boat AM 27MHz Pistol-grip
Drive System ..........................................................Direct Drive with Propeller Strut
Steering System .................................................... Off-set Rudder with Water Pickup
Speed Control .................................................. Water-cooled 45-Amp Brushless ESC
www.ProBoatModels.com
Built under license from
Ellstrom Manufacturing

Advertisement

Table of Contents
loading

Summary of Contents for Horizon Hobby miss elam

  • Page 1: Specifications

    ® Miss Elam 1/12 Brushless EP Catamaran Boat Owner's Manual Specifications Hull Length ..................26 in (660mm) Beam ................... 8.3 in (210mm) Motor ....... Water-cooled Hi-performance A3630-1500 Brushless Motor Radio System............Pro Boat AM 27MHz Pistol-grip Drive System ............Direct Drive with Propeller Strut Steering System ............
  • Page 2: Table Of Contents

    Introduction ® The Miss Elam Brushless EP comes ready-to- Thank you for purchasing the Pro Boat run with the Pro Boat 27MHz AM radio system Miss Elam Brushless EP ready-to-run boat. and electronic speed controller already Please read these instructions carefully before installed.
  • Page 3: General Guidelines

    Always stay clear of and wildlife. It is preferable to operate the the propeller. Miss Elam Brushless Catamaran in low wake, low wind conditions and in areas free of people, wildlife and objects. Additional Required Items You will need to purchase the following to get your boat on the water: •...
  • Page 4: Contents

    Contents • Miss Elam Brushless EP RTR • Pro Boat radio transmitter • Boat stand Section 1: Assembling the Boat Stand Attach the side stand pieces by interlocking them into the end pieces as shown. Secure the interlocking pieces with medium CA or epoxy.
  • Page 5: Section 3: Installing The 7.2V Ni-Mh Battery Packs

    Section 3: Installing the 7.2V Ni-MH Battery Packs Attach the hook and loop material to the Carefully remove the hatch from the hull. batteries and the battery boxes. The Pro Boat water-cooled ESC comes pre-wired with a Deans-style connector. Use a 6-cell battery pack listed below for optimum performance.
  • Page 6: Section 4: Adjusting The Transmitter

    Section 4: Adjusting the Transmitter Note: Refer to the radio instructions for Adjust the rudder trim knob so that the specific information on transmitter setup. rudder is centered prior to operation. You may adjust this control to make the boat run Adjust both the Throttle and Steering trims to straight during operation.
  • Page 7: Section 5: Checking The Radio System

    Section 5: Checking the Radio System The rudder control arm should move toward The ESC will beep until you give full throttle the front of the boat when right input is input. The auto sensing circuitry will given. Conversely, when left input is given, select full throttle position when you hold the control arm should move toward the back full throttle during initial setup.
  • Page 8: Section 6: Testing Your Boat In The Water

    Failure to do so may cause the boat to capsize. Section 7: Handling Adjustment Operate your Miss Elam Brushless EP in low You may also turn the dual rate dial to medium wake conditions to avoid having down to reduce rudder travel in rough problems with the boat overturning.
  • Page 9: Section 9: Speed Control Programming

    Section 9: Speed Control Programming The ESC in your Miss Elam Brushless EP Caution: It is imperative that you do not is preprogrammed from the factory. The attempt to use LiPo batteries in the Miss programming is set for Ni-MH batteries as Elam Brushless unless it has been properly shipped with your Miss Elam.
  • Page 10: Section 10: Lubricating The Drive Shaft

     4. Slide the flex shaft out of the stuffing box. Note: Running the Miss Elam Brushless EP RTR in salt water could cause some parts to corrode. If you run the boat in salt water, rinse it thoroughly in fresh water after each use and lubricate the drive system.
  • Page 11: Section 11: Warranty Information

    Section 11: Warranty Information Warranty Period Horizon Hobby, Inc., (Horizon) warranties that the Products purchased (the “Product”) will be free from defects in materials and workmanship at the date of purchase by the Purchaser. Limited Warranty (a) This warranty is limited to the original Purchaser ("Purchaser") and is not transferable. REPAIR OR REPLACEMENT AS PROVIDED UNDER THIS WARRANTY IS THE EXCLUSIVE REMEDY OF THE PURCHASER.
  • Page 12: Section 12: Replacement Parts

    • Moisture causes damage to electronics. Avoid prolonged water exposure to all equipment not specifically designed and protected for this purpose. Section 12: Replacement Parts If you have any questions concerning the setup or running of your Miss Elam Brushless EP boat, please call the Horizon Service Center toll-free at (877) 504-0233. PRB0100...

Table of Contents