NOTICE All instructions, warranties and other collateral documents are subject to change at the sole discretion of Horizon Hobby, LLC. For up-to-date product literature, visit www.horizonhobby.com and click on the support tab for this product. Meaning of Special Language: The following terms are used throughout the product literature to indicate various levels of potential harm when operating this product: WARNING: Procedures, which if not properly followed, create the probability of property damage, collateral damage, and serious injury OR create a high probability of superfi...
Box Contents Quick Start Information Transmitter Set up your transmitter using the Setup transmitter setup chart Hi Rate Low Rate 30mm 22mm 25mm 18mm Dual Rates 30mm 20mm 18mm 13mm Landing Takeoff Flaps =40mm =30mm Center of 55 – 70mm back from leading edge of wing at the fuselage.
Model Assembly Landing Gear Installation 1. Insert the landing gear assembly into the front mounting location on the bottom of the fuselage as shown. 3 x 16mm 2. Secure the landing gear into place with the four included 3 x 16mm (A) Tapered hex head machine screws and mounting straps.
Page 6
0, then adjust the clevis to center the control surfaces. • Turn the linkage clockwise or counterclockwise until the control surface is centered. • Attach the linkage to the servo arm or control horn after adjustment. Maule M7 www.modellmarkt24.ch; www.modellmarkt24.ch; www.modellmarkt24.de...
Scale Accessories Optional Install the non-functional scale antennas on the top of the wing. Insert the tab into the slot in the plastic fi tting and slide it toward the tail to lock the antenna in place. Float Installation Optional Float Assembly The water rudder is mounted on the left fl...
Receiver Access The receiver for the Maule M7 is located inside the fuselage below the cockpit. Slide the hatch latch toward the tail and remove the bottom hatch to gain access to the receiver. Battery Installation and ESC Arming Battery Selection The E-fl...
Transmitter and Receiver Binding / Switching ON and OFF SAFE Select This product requires an approved Spektrum ™ DSM2 ® /DSMX ® compatible Switching ON SAFE Select Binding Sequence transmitter. Visit www.bindnfl y.com for a complete list of approved transmitters. The aircraft has an optional SAFE Select feature, which can be switched ON or OFF easily by binding in a specifi...
3S 2200mAh. Always confi rm the CG is located correctly when changing the battery confi guration. 55 – 70mm +/- 3mm Back from the leading edge of the wing at the fuselage. Maule M7 www.modellmarkt24.ch; www.modellmarkt24.ch; www.modellmarkt24.de www.modellmarkt24.de...
AS3X Control Direction Test This test ensures that the AS3X ® control system is functioning properly. Aircraft movement AS3X Reaction Assemble the aircraft and bind your transmitter to the receiver before performing this test. 1. Raise the throttle just above 25%, then lower the throttle to activate AS3X technology.
Use low to medium throttle and hold up elevator to manage speed on the water during a high speed taxi. Maule M7 www.modellmarkt24.ch; www.modellmarkt24.ch;...
PNP Receiver Selection and Installation The Spektrum AR636 receiver is recommended for this airplane. Other receiver selections should be at least 6-channels and offer full range. Refer to the receiver AR636 Port manual for correct installation and operation instructions. Assignments CAUTION: When using a Futaba ®...
Select correct model memory on transmitter transmitter (ModelMatch radios only) Flight battery/Transmitter battery charge is too low Replace/recharge batteries Transmitter may have been bound to a different air- Bind aircraft to transmitter craft using different DSM protocol Maule M7 www.modellmarkt24.ch; www.modellmarkt24.ch; www.modellmarkt24.de www.modellmarkt24.de...
Troubleshooting Guide (Continued) Problem Possible Cause Solution Control surface, control horn, linkage or servo damage Replace or repair damaged parts and adjust controls Wire damaged or connections loose Do a check of wires and connections, connect or replace as needed Control surface does Transmitter is not bound correctly or the incorrect Re-bind or select correct airplanes in transmitter...
Product, (iv) attempted service by Return Merchandise Authorization (RMA) number. Pack the Product securely anyone other than a Horizon Hobby authorized service center, (v) Product not using a shipping carton. Please note that original boxes may be included,...
EFL5375 MAULE 1.5M PNP; Horizon Hobby, LLC hereby declares that this product is in compliance with the essential requirements and other relevant provisions of the EMC Directive. EFL5350 MAULE 1.5M BNF BASIC; Horizon Hobby, LLC hereby declares that this product is in compliance with the essential requirements and other relevant provisions of the RED and EMC Directives.
Optional Parts • Optionale Bauteile • Pièces optionnelles • Pezzi opzionali Part # | Nummer Description Beschreibung Description Descrizione Numéro | Codice Park Flyer Werkzeugsortiment, Assortiment d'outils park fl yer, Park Flyer assortimento attrezzi, EFLA250 Park Flyer Tool Assortment, 5 pc 5 teilig 5 pc EC3 Battery Connector, Female...
Page 21
E-fl ite, DSM, DSM2, DSMX, Bind-N-Fly, BNF, the BNF logo, Plug-N-Play, AS3X, SAFE, the SAFE logo, ModelMatch, Z-Foam, Passport, Prophet, EC3, and the Horizon Hobby logo are trademarks or registered trademarks of Horizon Hobby, LLC. The Spektrum trademark is used with permission of Bachmann Industries, Inc.
Need help?
Do you have a question about the Maule M7 and is the answer not in the manual?
Questions and answers