Section 10: Lubricating The Drive Shaft - Horizon Hobby miss elam Owner's Manual

Section 10: Lubricating the Drive Shaft

 3. Remove the propeller shaft from the
propeller strut. Make sure not to lose the
two Teflon washers on either side of the
propeller strut.
 4. Slide the flex shaft out of the stuffing
box.
 5. Lubricate the drive shaft with PRB0100
Water-Proof Marine Grease (see your local
hobby shop). Reinstall the drive shaft in
reverse order. Be sure to reinstall the
nylon washer between the universal and
the stuffing box.
Note: Running the Miss Elam Brushless EP
RTR in salt water could
cause some parts to corrode. If you run
the boat in salt water, rinse it thoroughly
in fresh water after each use and lubricate
the drive system.
Because of its corrosive effects, running
RC boats in saltwater is at the discretion
of the modeler.
Instructions for Disposal of WEEE by
Users in the European Union
This product must not be disposed of with other waste.
Instead, it is the user's responsibility to dispose of their waste
equipment by handing it over to a designated collection point
for the recycling of waste electrical and electronic equipment.
The separate collection and recycling of your waste equipment
at the time of disposal will help to conserve natural resources
and ensure that it is recycled in a manner that protects human
health and the environment. For more information about where
you can drop off your waste equipment for recycling, please
contact your local city office, your household waste disposal
service or where you purchased the product.
10