Finishing Sewing; Editing Parameters In Memory; Editing Parameters At The M1 Level - Dürkopp Adler 512 Assembly Instructions Manual

48

5.18 Finishing sewing

CAUTION
Risk of injury due to sharp and moving parts!
Cutting or crushing are possible.
Do not reach under the raised clamp.
1. Press the Ready button.
 The button LED illuminates. The controller is in the sewing
mode.
2. Main power switch OFF.
Note
If the sewing machine is switched off without pressing the Ready
button then any changed values are not saved.

5.19 Editing parameters in memory

5.19.1 Editing parameters at the M1 level

Prerequisite:
• Machine is in programming mode, Ready button LED is off.
1. Press and hold the Memory button for 3 s.
 The controller beeps once, the button LED lights up.
The Program display shows the parameter number, the
Function display shows the parameter value.
2. Press the +/– Program buttons to select a different parameter.
3. Press the Ready button to confirm the parameter.
 The button LED illuminates.
4. Press the +/– Function buttons to change values.
Operating Instructions 512/532 - 04.0 - 08/2016
Programming