Table of Contents
Advertisement
Technical Specifications
Operating Instructions 512/532 - 04.0 - 08/2016
2
Technical Specifications
The Dürkopp Adler 512 is a CNC double lockstitch bartack sewing
machine. Die Dürkopp Adler 532 is a button sewing machine.
2.1
Characteristics of the 512
The existing programs are scalable and can be saved in this
modified form. The machine is equipped with an automatic sewing
foot lifter, thread cutter, thread wiper, a needle thread clamp below
the stitch plate for reliable sewing-on and an integrated DC direct
drive including an operating panel.
Technical features
• The sewing machine is driven by an integrated positioning
drive. A controller controls the sewing drive and also 2 stepper
motors for the X and Y motions required for generating the
seam geometry.
• The clamps are raised by a stepper motor.
• The maximum size of the sewing field is 40 mm in the X direc-
tion (lateral to the arm) and 30 mm in the Y direction (parallel
to the arm).
• The upper section is oil-free. This means that there is no dan-
ger of soiling the sewn material with oil.
• The hook is lubricated by a wick lubrication system, fed from a
reservoir visible to the operator.
• 50 pre-programmed bartacks are available. The standard pat-
terns can be temporarily modified (changes to the total length,
total width, speed). When the machine is switched off, the
modified values of the most recently used bartack are restored
when the machine is switched on again.
• 50 additional modified standard patterns can also be stored.
• A maximum of 16,000 stitches can be stored.
• 25 sequence programs with up to 30 seam appearances per
sequence can be stored.
• The coordinate entry system has an accuracy of 0.1 mm.
• The machine has a bobbin thread decrementing counter and a
daily item counter.
• The arm shaft is directly driven by a brushless DC motor.
• Speeds of up to 3000 min
-1
can be set, in 100 min
-1
steps.
11
Advertisement
Table of Contents
