Referencing The Machine; Selecting The Seam Appearance; Scaling The Axes; Scaling The X Axis (Software Version Up To M2.10) - Dürkopp Adler 512 Assembly Instructions Manual

Programming
Operating Instructions 512/532 - 04.0 - 08/2016
5.3

Referencing the machine

1. Press the Ready button.
 The button LED illuminates.
2. Press the Ready button.
 The button LED goes out.
5.4

Selecting the seam appearance

NOTICE
Property damage may occur!
Damage to the needle if the size of the seam appearance
does not match the clamping foot.
Check the clamping foot and adjust if necessary.
Prerequisite:
• Machine is in programming mode, Ready button LED is off.
1. Press the +/ Function buttons until the seam appearance
–
number is shown in the Function display.
5.5

Scaling the axes

Important
Changes to the axes only take effect temporarily. For information
on making permanent changes and relocating the seam appea-
rance, see chapter saving seam appearances ( S. 43).
5.5.1

Scaling the X axis (software version up to M2.10)

1. Press the Select button until the X axis symbol LED illumi-
nates.
2. Press the +/– Function buttons until the desired X axis value
is reached. 100 % corresponds to the specified dimensions
of the selected seam appearance.
37