Configure Route Pattern - Avaya 9600 Series Configuring

3.7.

Configure Route Pattern

This section provides the configuration of the route pattern used in the sample configuration for
routing calls between SIP endpoints and other types of stations supported by Communication
Manager. To support routing when the primary Session Manager is not available, the route
pattern should be configured to use look-ahead routing (LAR) to select a secondary route.
Use change route-pattern n command where n is an available route pattern.
Fill in the indicated fields as shown below and use default values for remaining fields.
 Grp No
 FRL
 Numbering Format
 LAR
In the sample configuration, route pattern "50" was created as shown below.
change route-pattern 50
Grp FRL NPA Pfx Hop Toll No.
No Mrk Lmt List Del
1: 10 0
2: 14 0
3:
4:
5:
6:
BCC VALUE TSC CA-TSC
0 1 2 M 4 W Request
1: y y y y y n n
2: y y y y y n n
3: y y y y y n n
4: y y y y y n n
...
DJH Reviewed:
SPOC 07/08/2011
Enter a row for each trunk group defined in Section 3.6.2.
Enter "0".
Enter "lev0-pvt".
Enter "next" for first row. Use default value for second row.
Pattern Number: 1
SCCAN? n Secure SIP? n
Inserted
Digits
Dgts
ITC BCIE Service/Feature PARM
rest
rest
rest
rest
Solution & Interoperability Test Lab Application Notes
©2011 Avaya Inc. All Rights Reserved.
Page
Pattern Name: SIP trunks to ASM
No. Numbering LAR
Dgts Format
Subaddress
lev0-pvt
lev0-pvt
1 of 3
DCS/ IXC
QSIG
Intw
n user
n user
n user
n user
n user
n user
next
none
none
none
15 of 51
SM6-1_CMES