Add Sip Trunk Groups - Avaya 9600 Series Configuring

3.6.2. Add SIP Trunk Groups

Add the corresponding trunk groups controlled by the signaling groups defined Section 3.6.1
using the add trunk-group n command where n is an available trunk group number.
Fill in the indicated fields as shown below. Default values can be used for the remaining fields.
 Group Type:
 Group Name:
 TAC:
 Direction:
 Outgoing Display?
 Service Type:
 Signaling Group:
 Number of Members:
Note: once the add trunk-group command is completed, trunk members will be automatically
generated based on the value in the Number of Members field.
add trunk-group 10
Group Number: 10
Group Name: SIP-IMS to SILASM3
Direction: two-way
Dial Access? n
Queue Length: 0
Service Type: tie
On Page 2, set the Preferred Minimum Session Refresh Interval: field to "1200".
Note: to avoid extra SIP messages, all SIP trunks connected to Session Manager should be
configured with a minimum value of "1200".
add trunk-group 10
TRUNK PARAMETERS
Unicode Name: auto
SCCAN? n
DJH Reviewed:
SPOC 07/08/2011
Enter "sip".
Enter a descriptive name.
Enter an available trunk access code.
Enter "two-way".
Enter "y".
Enter "tie".
Enter the number of the signaling group added in Section 3.6.1.
Enter the number of members in the SIP trunk (must be within
the limits for number of SIP trunks configured in Section 3.1.2).
TRUNK GROUP
Group Type: sip
Outgoing Display? y
Auth Code? n
Group Type: sip
Preferred Minimum Session Refresh Interval(sec): 1200
Solution & Interoperability Test Lab Application Notes
©2011 Avaya Inc. All Rights Reserved.
COR: 1 TN: 1
Night Service:
Signaling Group: 10
Number of Members: 20
Redirect On OPTIM Failure: 5000
Digital Loss Group: 18
Page 1 of 21
CDR Reports: y
TAC: #10
Page 2 of 21
13 of 51
SM6-1_CMES