Sold Out Syrups; Mapping The Valves - Cornelius pbd175 Service Manual

PBD175 (Spire 3.0) Service Manual
Computer

Sold Out Syrups

This feature can be used to lock a brand or flavor from dispensing. One possible use is to lock a leaking valve that
needs to be replaced. The screen is shown in Figure 20.

Mapping the Valves

This feature allows the technician to change the brand or flavor that is displayed on the user interface screen. Possible
uses would be a brand or flavor change on a circuit, or during installation a wrong flavor was connected to a valve.
The valves in the dispenser may be mapped to allow any brand shown on the touch screen to be directed to any
valve. The only acceptations are the carbonated water and the four plain water valves, since the flow controls are
special for these two valves. Before brixing the unit, the technician should validate that the plumbed brand lines
from the python are correctly connected to the labeled brands on the user display screen. Enter Service mode,
shown in "Entering Service Mode" on page 14. Refer to "Mapping the Diagram" on Figure 104. This chart can also
be found in the Service mode menu on the dispenser.
To map the valves, perform the procedure in Table 4.
Step
1 To enter Service Mode, refer to "Entering Service Mode" on page 14.
2 Press the valve in the Valve Assignment area of the screen to reassign a flavor.
3 The Change Valve Assignment screen is displayed, as shown in Figure 21.
4 Pick the new assignment in the Change Valve Assignment screen. The dispenser prompts if the lines
have been purged, as shown in Figure 22.
5 Press "Yes continue with BIB change" or "No, continue with valve cleaning.
6 Repeat Step 2 thru 5 until all valves are properly assigned.
7 When finished press Close and then press Close.
Publication Number: 620062609SER
Figure 19.
Figure 20.
Table 4.
Action
- 16 -
NUC Power
Button
©2015-2016, Cornelius Inc.