Step 2: Assembling Postbase Mini - FP Postbase Mini Operator's Manual

10
PostBase Mini
Step 2: Assembling PostBase Mini
Caution! When you move PostBase Mini from a cold environment (i.e. below
10 °C / 50 °F): Unpack the PostBase Mini and wait at least 2 hours before
connecting PostBase Mini. PostBase Mini requires this period to adapt to the
ambient conditions.
• Unpack the packages.
• Check that the contents of the packages
are complete and free from any damage.
Keep the packing and the transport fixture for
the print system. Use it again when you need
to transport PostBase Mini or send it in to
service.
• Choose an installation site with the follow-
ing ambient conditions:
– room temperature: 15 °C to 35 °C (59 °F
– no direct sunlight
– power socket in the immediate vicinity
– network connection with internet access.
• Place PostBase Mini on a firm, level, low
vibration and horizontal base.
• Remove the protective foil from the display.
Mounting the weighing platform
Slot
• Hold the weighing platform such that the
slot in the weighing platform foot points to
the back.
• Place the weighing platform onto the scale
receptacle from above. The slot of the
weighing platform must slide in the coun-
terpart on the scale receptacle.
• Press down slightly on the weighing plat-
form with your flat hand.
to 95 °F)