Select Modem (=Ethernet); Select Rs-232; Get Version Information - CipherLab 8001 User Manual

30 8001/8300/8500 Ethernet Cradle User Guide
// Unless you have changed the baud rate setting via the DIP switch
onboard, pass the factory setting 1 (115200 bps) for Ethernet Cradle
and 3 (57600 bps) for Modem Cradle.
// Parity% = 4 for cradle commands
// Data% = 2 for 8 data bits
OPEN_COM(1)
Sendbase$ = "#vErSiOn?"
WRITE_COM(1, Sendbase$)
...

3.1 Select Modem (=Ethernet)

After issuing the command, the baud rate of the cradle will be reset to the DIP switch setting
Command: #mOdEm<CR>
Response: #DONE<CR>
Note: "Select Modem" here actually means "Select Ethernet" because the Modem Board

3.2 Select RS-232

After issuing the command, the baud rate of the cradle will be reset to the DIP switch setting
Command:
Response:
Note: Baud rate will be reset to the DIP switch setting when the RS-232 cable is plugged

3.3 Get Version Information

You can retrieve the version of IR board.
has been replaced by the Ethernet Board.
#SeRiAl<CR>
#DONE<CR>
#CABLE!<CR>
or unplugged.
OK
No RS-232 cable detected!