Timer & Line Terminator - CipherLab 8001 User Manual

22 8001/8300/8500 Ethernet Cradle User Guide
2.3.2 Timer & Line Terminator
Select "2" from the Setup Connection menu. The following submenu will be displayed.
Data sent to the cradle over IR is first buffered in the memory. The cradle will then transmit
the buffered data to a remote host when any of the following conditions is met:
The amount of data reaches the maximum data byte count that can be held in an IP
packet.
The cradle has not received any data for a period of time longer than the value of the
Timer setting.
The Line Terminator configured is received.
Timer
Transmit on Line Terminator
Specify a timer setting from 1 to 10,000, in units of millisecond.
By default, the timer is set to 10 milliseconds.
To change the timer setting, e.g. to 20 milliseconds, type "1 20" and press [Enter].
By default, this setting is enabled so that data received over IR will not be sent out as
a TCP/IP packet until the Line Terminator character is received.
To disable it, type "2 0" and press [Enter].