Front Bezel Replacement (Model 6C4) - IBM pseries 630 6C4 Installation Manual

Front Bezel Replacement (Model 6C4)

To replace the front bezel, do the following:
1. Open the front rack door and put the system into the service position as described
in "Placing the Model 6C4 into the Service Position" on page 53.
2. Put the two tabs located on the bottom edge of the bezel into their locking slots,
located on the chassis.
3. Pivot the bezel up toward the top of the chassis.
4. Align the release tabs to the matching slots located on the front of the system.
5. Gently push the tabs into the slots until the bezel seats against the front of the
system.
6. Push the system drawer back into the operating position as described in "Returning
the Model 6C4 to the Operating Position" on page 54.
7. Close the rack door.
Eserver pSeries 630 Model 6C4 and Model 6E4 Installation Guide
62