IBM pseries 630 6C4 Installation Manual page 104

28. Select Install/Configure Devices Added After IPL and press Enter. Then follow
the instructions on the screen. Successful replacement is indicated by the OK
message displayed next to the Command field at the top of the screen.
If your system is set up to run HACMP clustering, do not use Install/Configure
Devices Added After IPL. Consult with your system administrator, or software
support for the correct method to configure the replacement device.
29. If you do not have other adapters to replace, continue with the next step.
OR
If you have other adapters to replace, press the F3 key to return to the PCI
Hot-Plug Manager menu and then return to step 14 on page 85.
30. Press F10 to exit the Hot-Plug Manager.
If you have added, removed, or replaced any adapters, run the diag -a command.
If the system responds with a menu or prompt, follow the instructions to complete
the device configuration.
31. Replace the service access cover as described in "Service Access Cover
Replacement (Model 6C4)" on page 55 or "Service Access Cover Replacement
(Model 6E4)" on page 58.
32. On a Model 6C4, push the system drawer back into the operating position as
described in "Returning the Model 6C4 to the Operating Position" on page 54.
33. Connect the adapter cables.
34. On a Model 6C4, route the cables through the cable management arm.
35. On a Model 6C4, close the rack doors.
On a Model 6E4, close the bezel door.
Eserver pSeries 630 Model 6C4 and Model 6E4 Installation Guide
88