Step 9. Are All Of The Internal Options Installed; Step 10. Positioning The Model 6E4 And Display - IBM pseries 630 6C4 Installation Manual

Step 9. Are All of the Internal Options Installed?

These instructions are for systems that have internal options (such as adapters, disk
drives, or memory upgrades) already installed.
If you have internal options that are not installed, install them now. Refer to Chapter 4,
"Installing Options for the Model 6C4 and Model 6E4" on page 49, and then return here.

Step 10. Positioning the Model 6E4 and Display

If you are setting up a Model 6C4, continue on to "Step 11. Check Your Display or
Console Type" on page 26.
Position the Model 6E4 system unit and display (optional) at or near their installed
location.
Observe the following guidelines when you are positioning the system unit:
v This unit weighs between 32 kg (70.5 pounds) and 55 kg (121.2 pounds). Three
persons are required to safely move it. Using fewer than three persons to move it
can result in injury.
v Displays and ASCII terminals can weigh as much as 35 kg (77 pounds). Use caution
when lifting or moving the display or ASCII terminal.
v Leave enough space around the system unit to safely and easily complete the setup
procedures.
v Observe standard ergonomic guidelines while arranging your system unit so that you
can work comfortably and safely. For more information on arranging your workstation,
visit the Healthy Computing Web address at:
http://www.pc.ibm.com/us/healthycomputing.
v Be sure to maintain at least 51 mm (2 inches) of space on the sides of the system
unit and 152 mm (6 inches) at the rear of the system unit to allow the system unit to
cool properly. The front of the system requires a minimum of 76 mm (3 inches) of
space. Blocking the air vents can cause overheating, which might result in a
malfunction or permanent damage to the system unit.
v Place the system unit in a location where it can safely and easily reach any
necessary power outlets and network connections.
v Place the display or ASCII terminal in a stable and sturdy location.
Chapter 2. Setting Up the System
25