Step 26: Start Your System - IBM pseries 630 6C4 Installation Manual

Step 26: Start Your System

1. If an operating system has been preinstalled in your Model 6C4 or Model 6E4
system, or if you plan to install one now, refer to the operating system installation
documentation.
Note: Operating system installation is handled in one of the following ways:
2. If you want to run diagnostics on your system, go to Chapter 3, "Verifying the
Hardware Operation" on page 43.
3. Power on the system, as follows:
a. Look for OK in the operator panel display, which indicates that the system is in
b. Press the power button on the operator panel. The power LED on the operator
c.
The AIX Documentation library is available at the following web address:
http://www.ibm.com/servers/aix/library/techpubs.html. AIX documentation is also
contained on the AIX Documentation CD. The documentation information is made
accessible by loading the documentation CD files onto the hard disk or by mounting the
CD in the CD-ROM drive.
v Preinstalled at the manufacturing site.
v Installed from a CD-ROM if a CD-ROM drive is installed. The CD-ROM
drive is a customer-installable option for the pSeries 630 Model 6C4 and
Model 6E4.
v Installed from a NIM server. Refer to Network Installation Management
Guide and Reference for information on installing your operating system
from a NIM server.
standby mode. The green power LED should be blinking slowly.
panel stops blinking and stays on. 9xxx checkpoints appear in the operator
panel display.
1 Power-On Button
2 Power LED
3 Attention LED
4 SCSI Port Activity
5 Ethernet Port Activity
Follow the instructions on your display.
6 Operator Panel Display
7 (FS1) Front Serial
Connector (RJ48 Connector)
8 CSP Reset Button (Pinhole)
9 System Reset Button
Chapter 2. Setting Up the System
41