Non-Hot-Swap Power Supply Replacement - IBM pseries 630 6C4 Installation Manual

Non-Hot-Swap Power Supply Replacement

To replace a non-hot-swap power supply, do the following:
1. Grasp the handles located on top of the new power supply. Pivot the handles
upward to 90 degrees. This action puts the handle cams into the correct position to
help seat the power supply into its connector.
2. Carefully insert the new power supply into the bay originally used by the faulty
power supply.
3. Lower the power supply handles, carefully pressing the power supply into the
connector. The spring latch located on the underside of each handle will snap into
place, indicating that the power supply is seated correctly and locked into position.
4. Plug the power cable into the back of the power supply.
5. Reconnect the power source to the system.
6. The green LED located on the power supply comes on solid.
7. Replace the service access cover as described in "Service Access Cover
Replacement (Model 6C4)" on page 55 or "Service Access Cover Replacement
(Model 6E4)" on page 58. If you are servicing a Model 6E4, go to step 10. If you
are servicing a Model 6C4, go to step 8.
8. Push the system drawer back into the operating position as described in
"Returning the Model 6C4 to the Operating Position" on page 54.
9. Route the cables through the cable management arm.
10. Power on the system drawer as described in "Starting the System" on page 52.
11. If the Model 6C4 has successfully powered on, close the rack doors.
If the Model 6E4 has successfully powered on, close the bezel door.
Chapter 4. Installing Options
127