Table of Contents
Advertisement
Charter 6 – Configuration
Reason RT430/RT434
GNSS Precision-Time Clock
Chapter 6: Configuration
1
Web Interface
User Name and Password
Sending Configuration
RT430/434
This chapter describes how to configure the RT430/434.
The Reason RT430/434 GNSS Precision-Time Clock has a Web Interface for
configuring network parameters, time parameters, time synchronization outputs and
PTP standard, updating firmware, changing key, controlling access and manipulating
configurations.
To connect to the Web Interface, enter the unit Ethernet port IP address into the
address field of a web browser. For information on factory default settings of the
Ethernet ports, see Installation chapter. If the unit is not using factory default
settings, the current IP address can be obtained by the local HMI (LCD display and
keys).
A start page containing the unit status information opens once the Web Interface is
accessed. The remaining monitoring and configuring sections are on a menu on the
left. To access them, click the desired menu item. The configuring sections are:
Ethernet: allows configuring the network parameters.
Time Settings: allows configuring the time parameters.
Time Signals: allows configuring signals sent from outputs.
PTP: allows configuring PTP clock parameters in accordance with IEEE 1588.
Setup: allows manipulating configurations, changing access control and key,
and updating firmware.
The configuration sections should be edited one by one and at the end of each
section, it is necessary to transmit the changes made to the unit. Otherwise, the
changes will not be saved. When transmitting changes to the unit, username and
password will be required. Factory default username and password are:
Table 8: Factory default username and password
User name
Password
To send the new configuration to the equipment, click on the <Apply> button. Then
the username and password of the equipment will be requested.
configuration
1234
RT430/434
45
Advertisement
Table of Contents
