Ethernet; Prp (Only In Rt430); Figure 31: Section To Configure Network Parameters Of The Unit - GE Reason RT430 Technical Manual

Gnss precision-time clock

Hide thumbs Also See for Reason RT430:

Table of Contents

RT430/434

Ethernet

Once both entered, click on login and the equipment will update its configuration. A

message will be displayed informing the status of the update.

In case the new configuration is not transmitted to the unit, the changes will not be

saved and will be discarded once the Web Interface is closed.

The Ethernet section of the Web Interface allows enabling the PRP (only in RT430) and

configuring network parameters of Ethernet ports 1, and 2, gateway and DNS. RT434

will display four Ethernet ports.

To enable the Parallel Redundancy Protocol check the PRP Enabled box, as shown

below, and click on the <Apply> button. When using PRP, the Ethernet port 2 uses the

same Network parameters from Ethernet port 1. For this reason, the Ethernet 2

configuration keeps disable when PRP is enabled.

Chapter 6 – Configuration

RT430/434

Table of Contents

Reason rt434