Time Signals; Outputs; Figure 34: Section To Configure Time Signals Applied In The Outputs - GE Reason RT430 Technical Manual

RT430/434
4

Time Signals

Outputs

50
The Time Signals section of the Web Interface allows configuring the signals applied
to the outputs of the unit. See figure below:

Figure 34: Section to configure time signals applied in the outputs


TTL 1 / 2: allows configuring the TTL-level electrical outputs 1 and 2. Each
output has two terminals, one screw, and other BNC. Both terminals can be
used simultaneously although its configuration is unique, so the same signal
will be applied to both terminals;

OPTO 1 / 2: allows configuring the two TTL-Level optical outputs;

OC 1 / 2: allows configuring the two open collector outputs;

RS232: allows configuring the Out pine signal of the serial output.
Chapter 6 – Configuration
RT430/434