Table of Contents
Advertisement
M
AINTENANCE
Headlight Beam Adjustment
1.
Park the vehicle on a flat surface adjacent to a vertical wall. The front of the vehicle should be approximately 25
ft. (7.6 m) from the wall.
2.
Measure the distance from the ground to the center of the headlight.
3.
Mark the wall at the measured height.
4.
Turn the key to the ON position.
5.
Press the headlight switch to activate the headlights.
6.
With a rider in the vehicle, the brightest part of the headlight beam should be 8 in. (20 cm) below the mark on the
wall.
Top of beam
4 in. (10 cm)
below
center line
7.
Check both headlights in low and high (if equipped) beam settings.
8.
If a headlight needs to be adjusted, locate the three adjustment screws in the back of the headlight.
9.
Turn the screws to adjust vertically and horizontally.
10. Repeat steps until the headlight is properly adjusted.
Brake Light
Pressing the brake pedal activates the brake light. Check the function of brake light before each operation.
1.
Turn the key to the ON position.
2.
Press the brake pedal to activate the brake light.
3.
If the light does not activate when the pedal is pressed, check the bulb.
Brake Light Bulb Replacement
Light components can get hot if they have been in operation. Allow the lights to cool
before servicing to prevent burns to the skin.
NOTICE: Do not touch a halogen bulb with bare fingers. Oil
from skin leaves a reside that causes a hot spot and
will diminish the life of the bulb.
1.
Use a screwdriver to remove four rivets from the back of the
light and remove the back cover.
2.
Rotate the bulb and pull it from the light housing.
3.
Disconnect the bulb from the wire harness.
4.
Connect the new bulb to the wire harness.
5.
Insert the bulb and turn to secure in place.
6.
Install the cover.
64
Headlight center line
~25 ft. (7.6 m)
Hide quick links:
Advertisement
Table of Contents
