Scheduled Maintenance Chart - Bad Boy Stampede 4x4 Owner's Manual

M
AINTENANCE

SCHEDULED MAINTENANCE CHART

Perform all services at the maintenance interval reached first.
S – Indicates operations that need to be performed on vehicles subjected to severe use.
E – Indicates emission-related services. Failure to do this maintenance will not void the emissions warranty but may affect emissions.
D – Indicates services that must be performed by an authorized BAD BOY OFF ROAD dealer.
Item
Steering
Front suspension
Rear suspension
CV boots
Tires
Brake fluid level
Wheel lug nuts
Brake system function
Frame hardware
Engine oil level
Air filter
Coolant
Headlights and taillights
Engine oil and filter
D
Valve Lash
E
Front differential oil
Rear differential oil
S
Air filter
E
S
Brake pads
D
Battery
Prop shaft
S General lubrication
Shift linkage
D Steering
S Front suspension
S Rear suspension
Throttle body, air intake
E
ducts and flange
CVT belt
Cooling system
S Oil lines, fasteners
46
Interval
(perform at interval that comes first)
Hours Calendar Miles (km)
Daily
Daily
Daily
Daily
Daily
Daily
Daily
Daily
Daily
Daily
Daily
Daily
Daily
Initial Service
Initial Service
Initial Service
Initial Service
Weekly
10 Monthly
20 Monthly
50 3 Months
50 3 Months 500 (800)
50 6 Months
50 6 Months 500 (800)
50 6 Months 500 (800)
50 6 Months 500 (800)
50 6 Months 500 (800)
50 6 Months 500 (800)
50 6 Months
50 6 Months
Remarks
Check for smooth and free operation.
Inspect. Check for leaks and loose or missing
hardware.
Inspect. Check for leaks and loose or missing
hardware.
Inspect. Replace as needed.
Check condition and pressure.
Check for correct level.
Check for loose or missing.
Check for proper operation.
Check for loose or missing.
Check for correct level.
Inspect. Clean or replace as needed.
Check level.
Check operation. Replace bulbs as needed.
Replace oil and filter between first 12 and 25
hours or 250 miles (402 km).
Check and adjust between first 12 and 25
hours or 250 miles (402 km).
See engine manual or take to dealer.
Check oil between first 12 and 25 hours.
Check oil between first 12 and 25 hours.
Inspect. Replace as needed.
Inspect. Replace as needed.
Inspect terminals. Clean as needed.
Inspect and lubricate.
Lubricate all fittings, pivots, cables, etc. where
required.
Inspect, lubricate and adjust.
Inspect. Replace if excessive play is found.
Inspect. Replace if wear or leaks are detected.
Inspect. Replace if wear or leaks are detected.
Inspect for proper sealing. Clean as required.
Inspect. Replace as needed.
Inspect coolant strength seasonally.
Inspect for leaks and loose fittings.
Page
61
14
60
62
60
51
59
56
63
52
53
54
59
60
65
58
48
48
61
48
48
58
56