Operation; Safety; Pre-Ride Inspection; Engine Break-In - Bad Boy Stampede 4x4 Owner's Manual

SAFETY

Failure to operate the vehicle correctly can result in a collision, loss of control, accident
or rollover, and cause serious injury or death. Read and comply with all safety warnings
in the safety section of this owner's manual.

PRE-RIDE INSPECTION

Inspect and verify that the vehicle is in safe operating condition before each use to decrease the risk of an accident.
Check the items in the table to help ensure safe and reliable operation.
Item
Brake system/pedal travel
Brake fluid
Park gear
Front suspension
Rear suspension
CV boots
Steering
Tires
Wheel hardware
Frame hardware
Fuel and engine oil
Coolant
Coolant hoses and radiator
Switches and indicator lights
Air filter
Headlights
Brake light / taillights
Seat belts
CVT belt

ENGINE BREAK-IN

Correct operation of the engine during the break-in period is essential to the performance, reliability and life of the
engine.
The engine break-in period is:
• the first 5 operating hours of a new engine
• the first 5 operating hours of an engine that has been completely disassembled
• the first few minutes until the engine is warm at each operation
During these break-in periods, operate the vehicle in the following manner:
• Avoid engine speeds over 6000 rpm.
• Avoid long periods of idle time.
• Avoid long operating times at low engine speed.
• Avoid long operating times at the same engine speed.
• Avoid long operating times with a full load.
• Vary the engine speed during operation.
• Apply quick bursts of acceleration after the engine has warmed up.

OPERATION

Check for proper operation.
Check for correct level.
Ensure vehicle does not roll when in park (P), and P light illuminates in the driver informa-
tion center.
Inspect. Lubricate if necessary. Check for loose or missing hardware.
Inspect. Lubricate if necessary. Check for loose or missing hardware.
Inspect for damage. Replace if necessary.
Check for smooth and free operation.
Check condition and pressure.
Check for loose or missing hardware.
Check for loose or missing hardware.
Check for correct levels.
Check for correct level.
Inspect for leaks.
Check operation.
Inspect; clean or replace if necessary.
Check operation.
Check operation.
Check entire length of belt for damage. Check latch operation.
Check condition.
Check
O
PERATION
Page
60
60
61
14
51
56
51
19
59
63
63
14
25
58
29