Electronic Power Assisted Steering (Epas); Fuses; Lights; Headlight Bulb Replacement - Bad Boy Stampede 4x4 Owner's Manual

1/10 scale monster truck. ready-to-race with traxxas stability management
Table of Contents

Advertisement

ELECTRONIC POWER ASSISTED STEERING (EPAS)

The EPAS (if equipped) is not a serviceable system and requires no maintenance. If it is not working properly, refer to
the repair manual for replacement procedures or contact the dealer.

FUSES

NOTICE: Have the vehicle inspected by your dealer if fuses and relays continue to blow after they have been
replaced.
Do not use fuses with a higher amp rating than indicated.
A single fuse box is located under the front cowl and two fuse boxes are located under the seat.
1.
Remove the access panel in the cowl or the seat.
2.
Press the tabs on the sides of the fuse box covers to remove.
3.
Refer to the chart on the inside of the fuse block cover or the following illustrations for identification of fuses and
relays.
4.
Inspect the fuses and replace if blown.
5.
Replace the relays as necessary.
2A (SPARE)
15A (DIFF LCK) 2A (LCD)
5A (TAIL LTS) DIODE 2
15A (SPARE)
15A (ACC)
2A (LCD EN) 15A (HD/TL)
ACC
KEY RLY
RLY
2A (SPD SNSR)

LIGHTS

• Clean the lights frequently to maximize visibility.
• Replace burned out bulbs promptly.
• Always make sure the headlights are adjusted properly.
Do not operate this vehicle at night or in low light if any bulbs are burned out. Poor light-
ing reduces visibility that could cause an accident resulting in severe injury or death.

Headlight Bulb Replacement

Light components can get hot if they
have been in operation. Allow the lights
to cool before servicing to prevent burns
to the skin.
NOTICE: Do not touch a halogen bulb with bare fingers. Oil
from skin leaves a reside that causes a hot spot and
will diminish the life of the bulb.
1.
Rotate the headlight bulb to the left and pull it from the light
housing.
2.
Disconnect the bulb from the wire harness.
3.
Connect the new bulb to the wire harness.
4.
Insert the bulb back into the headlight and turn to the right to
secure in place.
TAIL LT
RLY
DIODE 1
CHMSL
FR DIFF RLY
RLY
ACC 12V
DIR BAT
MAIN
(30A)
(30A)
(50A)
5A (SPARE)
15A (SPARE)
5A (KEY SW)
25A (FAN)
MAIN RLY
Adjustment Screws
M
AINTENANCE
15A (SERV RLY)
15A (FUEL)
BRAKE
15A (DIR
15A (BAT
EN Rly
BAT)
RLY
FUEL
FAN RLY
ACC BLCK RLY
Rly
Headlight Bulb
63

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents