Continuously Variable Transmission (Cvt); Cvt Belt Inspection; Draining The Cvt; Prop Shaft - Bad Boy Stampede 4x4 Owner's Manual

M
AINTENANCE

CONTINUOUSLY VARIABLE TRANSMISSION (CVT)

Check and replace the CVT belt at the intervals indicated in the SCHEDULED MAINTENANCE CHART on page 46.
The CVT cover is located under the driver side truck bed. Lift the bed and/or remove the rear fender liner and side
panel to access the cover.

CVT Belt Inspection

1. Remove the air outlet and inlet hoses from the
CVT cover.
2. Remove the CVT cover screws and CVT cover to
access the belt.
3. Inspect the belt. If the belt needs to be replaced,
refer to the repair manual for procedure and
safety information.
4. Reinstall the cover and hoses.

Draining the CVT

If water gets into the CVT, use the following procedure to dry it out before operating:
1. Park the vehicle on a level surface.
2. Remove the drain plug from the bottom of the CVT cover.
3. Allow the water to drain completely.
4. After all of the water has drained out, replace the drain plug.
5. Move the gear shifter to the P (park) position.
6. Start the engine.
7. Alternately press and release the accelerator pedal for 10-15 seconds to
remove moisture and air-dry the belt and clutches. Do not hold the throttle wide
open for more than five seconds at a time.
8. Allow the engine to settle to idle speed.
9. Apply the brakes.
10. Move the gear shifter to L (low) range.
11. Test for belt slippage. If the belt slips, repeat the process.
12. Take the vehicle to your dealer for service as soon as possible.

PROP SHAFT

There are two universal joints on the prop shaft that require lubrication; one
in the center of the vehicle and one at the rear. Inspect and apply lubricant
to the universal joints at the intervals indicated in the SCHEDULED MAIN-
TENANCE CHART on page 46.
1. Inspect the prop shaft. A visible coat of grease must always be pres-
ent at both universal joints.
2. If lubricant cannot be seen, or if the lubricant appears contaminated,
apply universal joints grease or equivalent to the grease fittings.

VEHICLE IMMERSION

NOTICE: Vehicle immersion can cause major engine and drivetrain damage. Take a vehicle that has been
immersed to the dealer for thorough inspection to verify that it is safe for operation BEFORE start-
ing the engine.
If taking the vehicle to the dealer before starting it is impossible, perform the following procedure:
1. Remove the vehicle from the water completely. If it is impossible to remove the vehicle completely from the
water, at least move it to an area where the water is below the floorboard.
58
CVT Belt
CVT Drain Plug
Prop Shaft