Change Oil; Remove Engine Oil; Replace The Oil Filter - Bad Boy Stampede 4x4 Owner's Manual

M
AINTENANCE

CHANGE OIL

Tools
• ratchet
• socket, 13 mm
• universal strap wrench

Remove Engine Oil

1. Start the engine and let it to run until it is warm.
2. Turn off the engine.
Wear protective gloves to prevent scalding from hot engine oil.
3. Remove the engine oil.
a. Put a drain pan under the oil tank.
b. Remove the drain plug and seal.
c. Allow the oil to completely drain from the tank into
the pan.
Make sure you remove the correct
(15A service) relay to prevent the engine
from starting. Removing the wrong relay
or fuse may allow the engine to start when the key is turned.
Starting the engine after the oil is drained can cause serious
engine damage.
d. Remove the 15A service relay in the main fuse box
under the driver seat. Removing this fuse will interrupt
the power supply circuit to the ignition coil, injectors and
O sensor so that the engine will turn over without start-
2
ing.
e. Turn the key to activate the starter and let it crank for
five seconds. As the engine turns over, the oil is
pumped out of the engine.
f. Let the oil drain until it stops and then repeat two more
times to remove the remaining oil from the tank.
g. When all of the oil is pumped out of the tank, replace the
seal and reinstall the drain plug. Tighten the plug to 13.3
- 14.8 ft.lb (18 - 20 Nm).

Replace the Oil Filter

1. Remove the oil filter with a universal strap wrench.
52
• funnel
• drain pan
• torque wrench, ft.lbs.
Seal
Drain Plug
5A (SPARE) 15A (SPARE) 15A (SERV RLY) 15A (FUEL)
15A (DIR 15A (BAT
5A (KEY SW) 25A (FAN)
BAT) RLY
MAIN RLY FAN RLY
BRAKE
EN Rly
FUEL
ACC BLCK RLY
Rly
Oil Filter