Wiring; Connections; Installation Schematic Diagram For Drives - BONMET SDL10A User Manual

conditions.
●
When using heat generating equipment such as the regenerative brake option, install them with full
consideration of heat generation so that the servo drive is not affected. Install the servo drive on a
perpendicular wall in the correct vertical direction.

Connections

2.5
3.1.1 Note
●
All terminals and plugs must be screwed well, poor contact or disconnection could lead to accidents.
●
In order to prevent error movement caused by noise, please install isolation transformers and noise filter.
● The equipment must be grounded.
●
Do not put power lines and signal lines in a same conduit or their binding them together, the distance between
power lines and signal lines should be 30cm at least, otherwise it may cause interference.
●
Please use the shielded twisted wire as signal cable.
●
Do not switch power supply frequently. The maximum frequency should be no more than once per minute.
Connection
2.6
≥ 100 mm
≥ 25 mm
Air flow
≥ 100 mm
Figure 2-2 installation schematic diagram for drives
Chapter 3 Wiring
Control
Card
Power
48~80VDC
BONMET motion GmbH/www.bonmet.com/www.bonmet.de
≥ 25 mm
≥ 100 mm
Air flow
Motor
Controler
7