Installation; Notes For Installation; Installation Environment; Installation Direction And Space - BONMET SDL10A User Manual

Installation

2.1 Notes for
●
Do not bend or strain the cables between servo drive and motor；
●
When mounting the servo drive and servo motor, make sure to tighten all screws to secure the machine
in place；
●
Motor shaft must be concentric with the axis of transmission;
●
If the cable between drive and motor is longer than 10 meters, the cable must be thicken.

Installation Environment

2.2
●
Please install the servo system in the place without oil mist, dust or electrical control cabinet (ensure the
temperature below 50
●
Please install the servo system in the place without radioactive matters and combustibles.
●
Take an anti-vibration measure to guarantee that the servo drive is free from vibration impact, ensuring
the vibration under 0.5G (4.9m/s
●
Please install the servo system in the place without direct sunlight.
●
Interferential equipment nearby would take great effects to the power wire and control wire which will
cause miss operation. For normal operation, a noise filter or any other anti-jamming measures is
necessary to be carried out. Leakage current would increase after installing a noise filter, therefore an
isolation transformer can be used to avoid this problem. Possessing a reasonable alignment and inhibit
measures is very important because the control signal wire is easy to be interfered.
2.3 Dimensions（Unit: mm）

2.4 Installation Direction and Space

●
The equipment must be installed in the specified direction. Otherwise, a fault may occur.
●
Leave specified clearances between the servo drive and control box inside walls or other equipment.
●
Leave a large clearance between the top of the servo drive and the internal surface of the control box,
and install a fan to prevent the internal temperature of the control box from exceeding the environmental
Chapter 2 Installation
℃
, relative humidity below 80%. The long-term safety temperature below 40
2
).
Figure 2-1 Dimension drawings
BONMET motion GmbH/www.bonmet.com/www.bonmet.de
℃
)
6