Tcp/Ip Control; Ipset' Set The Ip Operation Mode, Dhcp Or Static - Zektor HDA604 User Manual

TCP/IP Control

The Zektor Switch can use DHCP to negotiate an address with a router, or it can be programmed to use
a static IP address.
The 'IPSET' command is used to switch between the two modes. 'IPSET 0' indicates a static address,
and 'IPSET 1' indicates a DHCP negotiated address.
To set a new static IP address, first issue the 'IPA', 'IPM' and 'IPG', commands to setup the IP address,
IP mask, and IP gateway, respectively. Then issue the 'IPSET 0' command.

'IPSET' Set the IP operation mode, DHCP or STATIC

This command is used to set the TCP/IP operating mode of the Zektor Switch. It allows you to choose
between DHCP and Static IP address operations.
When set to the DHCP, the Zektor Switch will negotiate an IP address, IP mask, and gateway address
(the address of the router), using DHCP.
When set to Static mode, the IP address, IP mask, and gateway address, given by the 'IPA', 'IPM' and
'IPG' commands will be used.
You can easily switch between the two modes without losing the static address setting. In other words
when switching to DHCP a new IP address values will be obtained from the router, but the static IP
address values of the 'IPA', 'IPM' and 'IPG' commands are not lost, and when returning to static
mode, these settings do not need to be resent.
The command format is:
^IPSET mode$
^IPSET ?$
Response String:
^=IPSET mode$
Where:
mode
To change the static IP address the 'IPSET 0' form of this command must be issued. This is true even
if you are already operating in the static mode. For instance if your static address is 192.168.1.200 and
you wish to change it to 192.168.1.201, you must first issue a 'IPA' command and then reissue the
'IPSET 0' command:
^IPA 192,168,1,201$
^IPSET 0$
58
Set new TCP/IP operating mode
Read the current TCP/IP operating mode
= Current operating mode. 0=Static, 1=DHCP.
Set the new static address
Tell the
Zektor Switch
Zektor Switch Serial Protocol, Version 0.16, 5/13/16
Advanced Control
to use the new static address