Li' Lighting Mode And Intensities - Zektor HDA604 User Manual

'LI' Lighting Mode and Intensities

Allows changing the behavior of the front panel backlight LEDs, and adjusting their intensities.
^LI mode,dim,bright,off$
^LI ?$
Response String:
^=LI mode,dim,bright,off$
Where:
mode
dim
bright
off
Response Example:
^=LI 3,020,090,010$
The mode settings allow you to set the front panel LEDs to always be: 0 - off, 1 - Always at the 'dim'
intensity, 2 - always at the 'bright' intensity, or 3 - auto-dim from 'bright' to 'dim' when the front panel
is not in use.
The intensities range for 0, which of off, to 100, which is full intensity.
When setting parameters, not all parameter have to be present, if a parameter is not present, it will be
left unchanged. For instance to change just the 'bright' value to 50%:
^LI ,,50$
Only the 'bright' intensity is affected.
Zektor Switch Serial Protocol, Version 0.16, 5/13/16
= Lighting mode (Settings: 0=Off, 1=Dim, 2=Bright, 3=Auto-dim)
= Intensity of dimmed LEDs (Range: 0-100)
= Intensity of brightened LEDs (Range: 0-100)
= Intensity of the standby power LED (Range: 0-100)
Set the 'bright' intensity to 50%
->
Advanced Control
Set mode and intensities
Query for current settings
Set mode and intensities
Mode=Auto, dim=20%, bright=90%, off=10%
57