Zektor HDA604 User Manual page 43

^HSZ.ch @zone,in$
^HSZ.ch @zone,+$
^HSZ.ch @zone,-$
^HSZ @zone,?$
^HSZ.ch @zone,?$
Response Strings:
^=HSZ @zone,in$
^=HSZ.ch @zone,in$
Where:
= One (or more) zones to be mapped.
@zone
in = Source to map to given zone(s).
= Channel bitmap.
ch
'HSZ' Examples
The 'HSZ' command in its simplest form:
^HSZ @1@3,2$
maps the source 2 to the zones 1 and 3. You can also map multiple zones and sources using a single
command. For instance:
^HSZ @1,2,@3,@4,7$
maps the source 2 to zone 1, and also maps the source 7 to zones 3 and 4.
By appending a '.' and a channel bitmap to the 'HSZ' command, the command can also be used to
breakaway the different channels:
^HSZ.8 @1,3
maps only the HDMI audio from HDMI input 3 to zone 1. The HDMI video on zone 1, remains
unchanged.
The channel (the '.8' in the above example) is a bitmapped number that indicates which channel or
channels are to be affected by the command.
The channels are mapped as:
1 = HDMI video
8 = HDMI audio
By adding together the above numbers, you can switch any combination of channels without affecting
the unselected channels.
For instance:
^HSZ.1 @3,4$
would map only the HDMI video from source 4 to zone 3. Audio would remain unchanged.
To map both the video and audio channels, add the HDMI video and HDMI audio channel numbers
together: 9 = 8 + 1, and use that as the channel number:
^HSZ.9 @2,@3,4$
This would map the HDMI video and HDMI audio channels from source '4' to zones '2' and '3'.
Which is the same as simply using: "
There are two forms of the query response string, depending upon whether any channel breakaway
options are in affect.
Zektor Switch Serial Protocol, Version 0.16, 5/13/16
Power, Switching, and Muting
Map only the selected channels of sources to zones.
Sequence zones forward through sources.
Sequence zones in reverse through sources.
Read current settings of given zones.
Read current settings of the selected channels of zones.
or,
", without the channel.
^HSZ @2@3,4$
43