Configuring Your System - Yale HSA3800 Installation, Programming, Operating

Configuring your system

Fine tune the operation of the control panel to your requirements; advanced
programming for PIRs and door/window contacts.
General settings menu
Pin code
To change PIN code, follow steps in 'Easy
install programming'.
Entry time
Enables you to alter the entry delay time.
Options available are 0 sec., 10 sec., 20 sec., up
to 70 sec. in 10-sec increments.
1 Use the arrow keys to switch between options.
2 Press OK to confirm.
• 10 sec. is set as factory default.
• Entry delay time applies only to the zone that a
door contact or PIR is installed and is set to
entry point.
Exit time
Enables you to alter the exit delay time.
Options available are 0 sec., 10 sec., 20 sec. up to
70 sec. in 10-sec increments.
1 Use arrow keys to switch between options.
2 Press OK to confirm.
• 10 sec. is set as factory default.
Alarm length
This is for you to select the period of time that
the control unit siren will sound when an alarm is
activated. You can choose from 1 minute to 15
minutes in 1 min increments.
1 Use arrow keys to switch between options.
2 Press OK to confirm.
• 3 minutes is set as factory default.
Control unit siren on/off
Enables you to set the control unit siren (not
external siren) to be silent in the event of an
alarm.
1 Press arrow keys to select the option.
2 Press OK to confirm.
• Siren ON is set as factory default.
• It is recommended that the control unit siren is
left on.
Exit sound
Switches on and off the exit countdown beeps.
1 Press arrow keys to select the option.
2 Press OK to confirm
• Exit Snd Low is set as factory default.
• The exit sound can be selected for high or low
volume.
Entry sound
Switches on and off the entry countdown
Downloaded from www.ukpanels.com
beeps.
1 Press arrow keys to select the option.
2 Press OK to confirm.
• Entry Snd Low is set as factory default.
• The entry sound can be selected for high or low
volume.
Door chime
Switches on and off the door chime in the
control unit when an entry sensor is activated.
1 Press arrow keys to select the option.
2 Press OK to confirm.
• Door Chime Off is set as factory default.
• The door chime can be selected for high or low
volume.
Listen-in
Switches on and off the listen-in feature if
privacy is required.
1 Press arrow keys to select the option.
2 Press OK to confirm.
• Listen-in On is set as factory default.
• It will not be possible to remotely listen-in or
listen-in on an alarm situation when this feature
is turned off.
Time
Allows you to set the current time (hours and
minutes).
1 Hours will flash, use arrow keys to select the
hour, 24-hour format is used.
2 Press OK to confirm the hour setting.
3 Now the minutes will flash, use arrow keys to
select the minutes.
4 Press OK to confirm.
• Time will have to be reset if all power to the
unit is lost.
Date
Allows you to set the current date.
1 Months will flash, use arrow keys to select the
month.
2 Press OK to confirm the month setting.
3 Now the day will flash, use arrow keys to select
the day.
4 Press OK to confirm.
• Date will be reset if all power to the unit is lost.
Interference
Allows you to set the control unit to respond to
the presence of radio jamming.
1 Use arrow keys to choose the setting.
2 Press OK to confirm the setting.
• 'Disp Off' is set as factory default.
• 'Disp On' will enable the display of any
interference that is detected for more than 30
15