Two-Way Voice Communication; Hands Free Calling - Yale HSA3800 Installation, Programming, Operating

Two-way voice communication

Opening two-way communication
In the event of an alarm, the call recipient can
press 1 to acknowledge the call and also initiate
two-way voice communication.
The two way voice communication channel
enables you to permit the recipient to listen in to
what is happening on your side. You can also talk
to the recipient through the microphone and
speaker on the control unit, hands free.
The communication channel, once opened,
lasts for 5 minutes. The recipient will hear
repeated beep sound 20 seconds before the
control unit hangs up the line.
If the recipient wants to have more time to
listen and talk, they can press the 1 button on
their telephone set again to add another 5
minutes.
• When the recipient opens the two way voice
communication channel by pressing 1, the
control unit will then stop the audible alarms to
allow speech communication.
• If the call is not terminated with a 0 or 9 within
5 minutes, it is acknowledged as one of the 2
attempted calls and will not re-activate the
sirens. It will re-dial if a previous
acknowledgement has not been registered.

Hands free calling

The control unit provides the convenience of
functioning as a hands-free phone.
You can dial the phone number on the keypad
of the control unit, communicate with the call
recipient using the built-in microphone and
speaker without lifting your hand-set. To do this,
follow the procedure below.
1 If the system is in disarmed mode or home
mode, press the key on the keypad.
2 The display will show a prompt asking for
confirmation.
3 Press OK to confirm. The control unit will pick
up the phone line and allow you to enter the
telephone number.'
• Pressing a will return the display to 'Alarm
Off'.
4 You can key in the telephone number, the
number entered will be dialled.
5 Voice communication is now enabled.
6 To hang up you can either press the a or
Downloaded from www.ukpanels.com
Terminating two-way communication
After two-way voice communication has been
initiated, the recipient can terminate the
communication by pressing 0 or 9 on their phone
set.
Terminating with 0 key
If the recipient presses 0 on their phone set,
the following will happen.
The two-way voice communication will be
terminated.
The audible alarm will continue.
The control unit will go back offline.
The control unit will try to dial the phone
number of the next priority until a total of 2 calls
have been acknowledged.
Terminating with 9 key
The two-way voice communication will be
terminated.
The control unit will go back offline.
The alarm will be silenced.
The control unit will stop dialling.
key or press the disarm button on the remote
control.
• 30 minutes is allowed for one call. The control
unit will hang up automatically after 30 minutes.
You will hear a repeated beeping sound
beginning 20 seconds before the call is
disconnected.
• If you want to continue the conversation, press
any numeric key on the keypad of the control
unit, another 30 minutes will be added.
• If you want to hang up, you can either press
the a or
key or press the disarm button on
the remote control.
The control unit will then disconnect the line
and go offline.
• During hands-free conversation, pressing Arm
button or Home button on the remote keyfob
control, the control unit will not respond.
23