Yale HSA3800 Installation, Programming, Operating page 7

PIR movement detector
Remove the fixing screw and cover assembly
and insert the three AA batteries as shown.
• The light steadily flashes for 30 seconds while
components initialise.
Magnet
Door/window contact
1 Remove the cover by loosening the fixing
screw.
2 Insert the two AAA batteries as shown. The
indicator will flash briefly.
Downloaded from www.ukpanels.com
Tamper Jumper switch
switch
Learn/Test button
Extension terminals
Tamper
switch
Learn/Test
button
Jumper
switch
3
A
b
Keypad remote control accessory
Remove the cover and insert the PP3
battery as shown. The 'Tx' LED will flash
briefly while components initialise.
Smoke detector accessory
Remove the cover and insert the four AAA
batteries as shown.
Learn/Test button
Keyfob remote control accessory
Slide off the battery cover, insert the
23A/MN21 battery as shown, and replace
cover. Switch to 'on'.
Help button accessory
Remove the cover by loosening the fixing
screw and insert the 12V battery (supplied) as
shown. Please
ensure you
observe
battery
polarity.
7