Yale HSA3800 Installation, Programming, Operating page 21

Changing/deleting telephone numbers
1 In the 'Tel. Numbers' display, using the arrow
keys, move the cursor to the telephone number
you wish to change.
2 Press OK.
3 Press OK to confirm you wish to change the
number.
• Press a to abort and the screen returns to Tel.
Numbers List screen.
4 Enter the new telephone number.
5 Press OK.
The number entered will override the previous
entry. The display returns to the 'Tel. Numbers'
list.
• If you wish to delete a telephone number and
leave the location empty, press OK when
reaching step 4. The location will be cleared
and the display will return to 'Tel. Numbers' list.
Storing alarm messages
The control unit allows you to record messages
to be relayed to the recipient that are specific to
the cause of the alarm.
Messages
Alarm messages are recorded in five separate
parts, with a total recording time of 16 seconds.
Address message
Burglar message
Fire message
Personal attack message
Medical emergency message 2 seconds
When an alarm is raised, the control unit will
dial the stored phone numbers according to
priority (A through to F). The address message will
be relayed, followed by the message specific to
the cause of the alarm. For instance an alarm
started by a smoke detector will cause the fire
message to be relayed.
Recording address message
Ideally your address message should contain
your family name, house number and street name
so that the recipient can quickly identify the
source of the message. For example: 'Smith,
number 10, Wood Street.'
1 Enter the 'Tel. Settings' menu, select
'Messages' > 'Record Msg' then 'Rec.
Address'. The display will ask for confirmation.
2 Press OK. A prompt message will be displayed
and the control unit will sound a long beep. At
this point recording starts.
Downloaded from www.ukpanels.com
3 After saying your address message, press OK.
• At any time, pressing a will abort recording
• The maximum length of the address message
• When recording messages ensure you are
Recording specific part messages
display will show the specific message menu.
Select each message in turn, following the same
procedure as for recording the address message.
Ensure you are brief when recording specific
messages. For example, when recording the
burglar message: 'Burglar, burglar'.
• The message length for each specific message
• Specific messages have to be recorded for
Playing messages
8 seconds
2 seconds 1 Select 'Play Message' and then press OK. You
2 seconds
2 seconds
2 Move the cursor to select the desired message
3 After the address part message is played
4 After playing the specific part message, the
• During playing the message, pressing the a
Changing a message
of the recorded message, just follow the same
procedure to record a new message for that part.
The new message will override the previous one.
The display will then allow you to record your
specific alarm messages.
and the message will not be stored. The display
will return to the menu.
is 8 seconds. When the 8 seconds are over,
recording will stop automatically and the
message recorded will be stored.
facing the microphone and within 30cm of the
control unit.
After recording your address message the
is 2 sec only.
specific alarms, eg fire messages for a fire
alarm, panic message for a panic alarm etc.
otherwise the wrong message might be sent.
are prompted to select the appropriate
message to be played.
and then press OK. The address part message
will first be played.
completely, the selected specific part message
is played accordingly.
address part message is played again and starts
a new cycle. Playing the message will be
repeated for a total of 5 times, and then the
screen returns to 'Play Selection' menu.
key will stop the playing and the screen returns
to 'Play Selection' menu.
If for any reason, you want to change any part
21