Yale HSA3800 Installation, Programming, Operating page 9

programmed into zone 1 as an entry point
detector.
9 Press OK.
• Press a to return to previous menu.
• To return to 'Alarm off' (normal mode), press a
repeatedly.
Add the PIR movement detector
1 Select 'Devices +/-' by scrolling down the
Programming menu and press OK.
2 Select 'Add Devices' and press OK.
3 Press the learn/test button the rear of the PIR.
• The control unit will show it has detected the
device by displaying
'Detected: (Ok?) PIR
sensor'.
4 Press OK.
5 You are prompted to
select a zone. The
cursor will flash at the
next available zone (in
this instance zone 2),
press OK.
• As with the
door/window contact, PIRs can be used in
various applications to suit your needs (see
'Further programming' page 16). For this
example the PIR is programmed as a 'Burglar'
detector. When used as a burglar detector,
when the system is armed and the PIR
activated, the alarm will sound instantly.
6 Select 'Burglar' from the list displayed and
press OK.
7 The display now shows the selected settings:
PIR Zone02 B – PIR programmed into zone 2 as
a burglar detector.
8 Press OK.
9 Press a repeatedly until display shows 'Alarm
Off'.
Downloaded from www.ukpanels.com
Add the siren unit
WARNING
The siren is very
loud, be prepared! Take
care not to activate the
siren tamper switch
unnecessarily.
The siren is
programmed by the
jumper switches in the
left hand compartment.
1 Lift off jumper number 1 and park it. The siren
will beep and flash. The siren is now in learn
mode.
2 Lift off jumper 5 and park it. This must be left in
Learn/Test
button
the 'off' position permanently.
• If jumper 3 and jumper 4 are removed during
the learning-in process, the siren will only be
activated for 1 second if accidently activated
and is useful for testing. Ensure the jumpers
are placed into the positions desired before
replacing the cover.
3 Program the control unit by selecting 'Devices
+/-' menu, then 'Program Siren' menu, then
'Learn Siren'.
4 Press OK and the unit will give a long beep to
confirm - the siren will also respond by a beep
and a flash.
5 Replace jumper 1 to the on position, the siren
will beep and flash to confirm.
6 To ensure siren does not activate, disable the
tamper switch by selecting 'Program Siren'
menu on the control unit, then 'Siren A/T Off',
and press OK.
• The siren disable tamper will automatically
revert to on after about an hour if not switched
back on again manually by selecting 'Siren A/T
On'.
• Press a to return to a previous menu.
• To return to 'Alarm off' in normal mode, keep
pressing a repeatedly.
Further siren programming
The siren can be configured to your personal
requirements by the use of jumpers.
Siren jumper programming
J7
J6
J5
J4
J3
J2
J1
Jamming detection
Clear memory (leave On)
Slave mode (leave Off)
Siren activation time
Siren activation time
Strobe activation mode
Learning-in mode (leave On)
9