Using The System - Yale YL-SR-320 Manual

5

Using the System

Note! The PIR Motion Detector and PIR
Image Camera have a built in battery save
mode. After detecting motion, they will wait
for one minute without motion before sending
any signals to the Smart Hub. This saves
battery power.
Changing your Key Pad PIN
The default Key Pad PIN is 1234. You can set up to 6 sets
of 4 digit PIN numbers by:
Arming and Disarming your Alarm
Using the Yale Home System App
10
Setting up Home Arm Mode
The Home Arm Mode allows the home to be partially
armed so that no one can get inside without first disarming
the system. However, the person inside the house can
move freely around without triggering the alarm. Home
mode is usually used to protect the ground floor when you
are upstairs in bed.
To enable Home Arm, you need to choose the sensors
to be ignored whilst in this mode. It would typically be the
bedroom PIR etc if you want to arm your system during
the night. These sensors should be set to Home Omit in
order to be ignored during Home Arm Mode. If you wish
to trigger an alarm count down with a sensor during Home
Arm Mode, allowing you time to disarm the alarm when
coming home, please select the mode: Home Access.