Yale HSA3800 Installation, Programming, Operating page 24

Hands-free call answering
If the system is in Disarmed mode or Home
mode, when the telephone rings you can answer
the call without lifting a handset.
1 When the telephone rings, the screen will
display 'Ring!'.
• The control unit itself will not produce a ringing
sound when an incoming call is received.
2 If you want to answer the call hands-free, press
the key.
3 Press OK to confirm; the control unit will go
online.
4 Voice communication is now enabled; you can
then converse with the caller through the
microphone and speaker on the control unit.
5 To hang up either press the a or
press the Disarm button on the remote keyfob
control.
• The control unit will hang up automatically after
30 minutes. You will hear a repeated beeping
sound beginning 20 seconds before the call is
disconnected.
• If you want to continue the conversation, press
any numeric key on the keypad of the control
unit, another 30 minutes will be added.
If you want to hang up, you can either press
the a or
key or press the Disarm button on the
remote keyfob control. The control unit will then
disconnect the line and go offline.
• A keyfob can also be used to answer an
incoming telephone call by pressing the Disarm
button twice for 1 second with a pause
between and then to close the call by pressing
the Disarm button again for 1 second.
24
key or
Downloaded from www.ukpanels.com
Remote access
The control unit gives you the power to control
your system remotely through the telephone line.
1 Dial your phone number.
2 Hang up on the first ring.
3 Wait 8-15 seconds.
4 Dial your number again.
5 The control unit will answer the phone on the
first ring of that second call.
6 Key in your PIN Code within 3 seconds.
7 If the PIN code is correct, you will hear a long
beep, then press the appropriate key as
follows.
Press 1 Open the two way communication
channel. You can then listen in to what is
happening in your house or talk to anybody at
home through the microphone and speaker on the
control unit.
Press 2 Put the system into a fully armed mode
(arm the system)
Press 3 Disarm the system
Press 5 Turn on the microphone (listen only)
Press 6 Turn off the microphone
Press 7 Activate siren
Press 8 Deactivate siren
Press 9 Check the system mode
Press 0 To hang up
• After you press 1 to open the Two Way Voice
communication channel, you can press 0 to
close the channel or the control unit will hang
up automatically after 5 minutes.
• If you want to continue talking or listening,
press 1 again, and another 5 minutes will be
added.
• When you press 9 to check the system mode,
the control unit will report a long tone to show
the system is armed, 2 pips for home armed, 3
pips for disarmed and 5 pips if there has been
an alarm event.
• Remember to press 0 before you hang up, or
the control unit will hang up automatically 30
seconds after (except in the situation that the
two way communication channel was opened
by pressing 1, in this case the control unit will
hang up 5 minutes after).