Wiring A Door Strike Lock (Normally Open); Wiring A Maglock (Normally Closed) - Chamberlain EL1SS Installation And Programming Manual

INTRODUCTION

WIRING A DOOR STRIKE LOCK (NORMALLY OPEN)

The door strike can be connected to Relay 1 or Relay 2.
See the Programming section for information about
configuring Relays 1 and 2.
AC or DC Power

WIRING A MAGLOCK (NORMALLY CLOSED)

The maglock can be connected to Relay 1 or Relay 2. See the
Programming section for information about configuring Relays 1
and 2.
INSTALLATION
Door Strike
NOTE: Do not use the unit's
power supply for the door strike.
NOTE: For AC power install a
Siemens S10K30 MOV
(Metal Oxide Varistor)
or equivalent.
NOTE: For DC power install a 1N4001
diode or equivalent.
AC or DC
Power
NOTE: For DC power install
a 1N4001 diode or equivalent.
TESTING
COM (Common)
NO (Normally Open)
Maglock
NOTE: Do not use the
unit's power supply for the
maglock.
10
PROGRAMMING
• Wire connectors can be
removed to simplify
wiring.
• DO NOT overload wire
connectors. Use
ONLY one wire per hole.
COM (Common)
NC (Normally Closed)