General Instruction - Chamberlain EL1SS Installation And Programming Manual

INTRODUCTION

GENERAL INSTRUCTION

NOTE: Use the STAR Key "*" to cancel any input.
PROGRAMMING INSTRUCTION
General Programming
Code Programming
Relay Programming
Level Adjustment
NOTE: Keypad commands are to be entered in a single string to result in success (indicated by double high success tone). Stop and go
keystrokes will result in negative tones (low single and triple fail tones).
CHANGE THE MASTER CODE
1. Enter the Master Code:
2. Enter the Program Code:
3. Enter: # # #
4. Enter the new Master Code:
will beep.
Write down the Master Code and store in a secure
location.
ENABLE TELCO (NO INTERCOM) MODE
Telco Mode is using the main telephone line for the unit's
communications to the house or complex.
1. Enter the Master Code:
2. Enter the Program Code:
ENABLE INTERCOM (NO TELCO) MODE
Intercom Mode is a stand alone system that allows
communication between the unit and a resident's phone
1. Enter the Master Code:
2. Enter the Program Code:
MICROPHONE SENSITIVITY
Allows the resident to hear the visitor at the unit,
1 = Low, 2 = Medium and 3 = High. Default level is 2.
1. Enter the Master Code:
2. Enter the Program Code:
3. Enter the Volume Level:
INSTALLATION
SYNTAX
Master Code + Command
Master Code + Command + Code
Master Code + Command + Setting
Master Code + Command + Setting
? ? ? ?
0 9 The unit will beep.
? ? ? ? The unit
? ? ? ?
0 4
? ? ? ?
0 3
? ? ? ?
0 7
1 or 2 or 3
TESTING
KEYSTROKES
1234 + 1 (12,123)
1234 +1(12) + 1234
1234 + 123 + 1234
1234 + 12 + 1-3
ENABLE PARALLEL RELAY OUTPUT (DEFAULT)
1. Enter the Master Code:
2. Enter the Program Code:
ENABLE INDEPENDENT RELAY OUTPUT CONTROL
1. Enter the Master Code:
2. Enter the Program Code:
SPEAKER VOLUME
Allows the visitor to hear the resident at the unit,
1 = Low, 2 = Medium and 3 = High. Default level is 2.
1. Enter the Master Code:
2. Enter the Program Code:
3. Enter the Volume Level:
ADJUST RELAY OUTPUT TIME (RELAY 1)
The amount of time (in seconds) the relay remains active.
Default level is 0.5 seconds.
1. Enter the Master Code:
2. Enter the Program Code:
3. Enter the Output Time (in seconds):
Example:
0000 = 0.5 Seconds (Minimum)
0010 = 10 Seconds
8000 = 8000 Seconds (Maximum)
14
PROGRAMMING
? ? ? ?
0 2 1
? ? ? ?
0 2 3
? ? ? ?
0 6
1 or 2 or 3
? ? ? ?
0 2 4
? ? ? ?